Setting Down, Transportation And Storage - Miele Complete C1 Mode D'emploi

During vacuuming (dia. 24)
,
When vacuuming fine dust, e.g.
sawdust, sand, plaster, flour, talcum
powder etc., electrostatic charges
build up naturally. Under certain
conditions these charges will be
released. To avoid the unpleasant
effects of these discharges, a metal
inlay has been incorporated into the
underside of the handle. Please
make sure that you keep your hand
in constant contact with this metal
strip during vacuuming.
Setting down, transportation
and storage
Park system for pauses whilst
vacuuming (dia. 25)
The Park system allows you to
conveniently park the suction tube and
floorhead during pauses.
^ Slot the floorhead into the parking
attachment at the back of the
vacuum cleaner.
If your vacuum cleaner is on a
sloping surface, e.g. a ramp,
- retract the telescopic tube fully
- do not use the park system if your
vacuum cleaner has an EasyLock
suction tube!
Park system for storage (dia. 26 + 27)
,
Always disconnect the vacuum
cleaner from the electrical supply
when you have finished using it.
Switch it off at the wall socket and
unplug it.
All manuals and user guides at all-guides.com
^ Press the release button on the lower
^ Push the connection piece attached
^ Stand the vacuum cleaner upright.
^ Slot the floorhead downwards into the
This makes the vacuum cleaner easier
to carry or store.
Maintenance
The Miele filtration system consists of
three filters.
– Dustbag
– Dust compartment filter (for motor
– Exhaust filter
These will need to be replaced from
time to time to ensure that your vacuum
cleaner performs efficiently.
If your vacuum cleaner has an
EasyLock suction tube you can
separate the two sections for storage
purposes.
section and pull the top section out.
to the upper tube into the lower tube.
If your vacuum cleaner has a
telescopic tube, retract the tubes fully
so that it takes up less room for
storage.
parking attachment on the side of the
vacuum cleaner.
,
Always disconnect the vacuum
cleaner from the electrical supply for
maintenance work and for cleaning.
Switch off at the wall socket and
unplug it.
protection)
en
35