Explosion Protection Identification - Titan RX-80 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

• Contact your coating material supplier about the compatibility of material

with aluminum.

HAZARD: GENERAl

This product can cause severe injury or property damage.

• Read all instructions and safety precautions before operating equipment.

• Never spray near sources of ignition; e.g. open flames, cigarettes — also

cigars and pipes are sources of ignition —, sparks, hot wires and hot

surfaces, etc.

• Wear respiratory equipment when spraying. The operator must be provided

with a protective mask.

In order to prevent work related illness, the manufacturer's regulations for

the materials, solvents, and cleaning agents used must be observed when

preparing, working with and cleaning the unit. Protective clothing, gloves,

eyewear, and, in certain cases, protective skin cream are necessary to protect

the skin.

• Follow the coating material and solvent manufacturer's warnings and

instructions.

• Extraction equipment should be installed by the user in accordance with

local regulations.

• The objects being sprayed must be earthed.

• Before each use, check all hoses for cuts, leaks, abrasion or bulging of cover.

Check for damage or movement of couplings. Immediately replace the hose

if any of these conditions exist. Never repair a paint hose. Replace it with

another grounded high-pressure hose.

• Pulling the trigger causes a recoil force to the hand that is holding the spray gun.

The recoil force of the spray gun is particularly powerful when the tip has

been removed and a high pressure has been set on the airless high-pressure

pump. Therefore, when cleaning without tip set the pressure control valve

to the lowest pressure.

• Use only manufacturer authorized parts. User assumes all risks and liabilities

when using parts that do not meet the minimum specifications and safety

devices of the spray gun manufacturer.