Parameter Setting - Kasanova E-MOTIKA Manuel D'instruction

INSTRUCTION MANUAL
81
border light up according to the actual quantity of charge. If all of the 10 segments will black out
and the border is blinking, the battery needs to be charged immediately.
Battery status indication

6.5 Parameter Setting

6.5.1 Parameters to be Set:
1 Data reset
2 km/mile
3 Light sensitivity
4 Display backlight brightness
5 Automatic off time
6 Maintenance warning settings
7 Input of the password
8 Wheel diameter selection
9 Setting speed limit
6.5.2 Entering setting mode
When the display is active, press twice (interval < 0.3 seconds). the system will enter the
menu parameter setting state, in which the display parameters can be set. Press twice again
(interval < 0.3 seconds) to return to the main menu.
Menu for entering the parameter settings.
In the parameter setting state, when the parameter you want to set begins to flash, press /
to adjust the parameter value. Briefly press to switch between the parameters you need to
set. Press twice (interval < 0.3 seconds) to exit the sub menu. If no operation is performed
for 10 seconds, the display will return to the normal riding display.