Kasanova E-MOTIKA Manuel D'instruction page 66

E-MOTIKA
66
2. Loose the bolts on stem and take out the fixing cap.
3. Put the handlebar on the stem and install it with fixing cap.
4. Adjust the handlebar angle and then, tighten the 4 bolts.
1. Handlebar
2. Fixing cap
3. Hexagon wrench
4. Bolt
Assembly requirements
In order to ensure the cycling safety and using performance, the fastening
ments for the standard parts in the right position are as follows:
1. The tightening torque of the front wheel nut is not less than 18 N.m
2. The tightening torque of the rear motor nut is 35 to 45 N.m
3. The tightening torque of the middle axis component lock is not less than 50 N.m
4. The tightening torque of the core screw rod in the Vertical handle stems is 15 to 18
N.m
5. The tightening torque of the Across handle Stems and the Vertical handle stems is
15 to 18 N.m
6. The tightening torque of the saddle pipe ring is 6 to 8 N.m
7. The tightening torque of the saddle and the Seat post ring is 15 to 18 N.m
8. The tightening torque of the Brake handle is not less than 10 to 12 N.m
9. The tightening torque of the Derailleur is 8 to 10 N.m
3. FUNCTIONING AND ADJUSTMENT
3.1 Charge
As it will last a certain period of time for the ex-factory, transport and storage of a just pur-
chased new bike, it is likely to result in shortage of the battery power and therefore, the
battery should be charged before using it.
The charger configured or designated by our company must be used for charging; oth-
erwise it might damage the battery, and may even lead to fire and other danger, but no
warranty is provided by our company.
3.2 Charging steps and method
1. Check carefully whether the rated input voltage of the charger is consistent with the
voltage of the power grid.
require-