Pioneer DVD-D304 Mode D'emploi page 9

3. Insert the DVD-ROM drive.
Slide the drive along the left and right
guides of the Changer and insert into the
half of it.
When installing more than one new add-
on drive at a single time, install each drive
from the bottommost empty drive bay
on upward. (Installing drives from the
upper drive bays on downward will make
it impossible to insert the necessary
connectors.)
4. Complete installation of the DVD-
ROM drive:
Reconnect the two wiring connectors on
the left, and the one on the right.
Note: Harness (wire) color
Drive No. 4 (top) ...................................... black
Drive No. 3 (third from the bottom) ............ blue
Drive No. 2 (second from the bottom) .... yellow
Drive No. 1 (bottom) .................................. red
Be sure the drive has been fully inserted
into its slot, then secure it in place with
the two screws at left and right.
Fix the right and left cables in place using
the cord holders, and then fix neatly into
place. Unused power cables to the right
must be returned to their original
position.
* When installing two or more drives,
repeat steps 3 and 4 for each drive to be
installed.
INSTALLING THE DVD-ROM DRIVE
Do not change the positions of
these switches which are intended
for use in servicing.
Warning
Adjust the cables carefully into position so
that they do not obstruct the rear panel.
Cord holder
Cord holder
9
En