Preparation For Work - Agu IHE3 Eaglet Mode D'emploi

clean the measuring sensor lens, wait at least several minutes before
further measurements in order to ensure the initial operating temperature.
When using this product, please observe the instructions listed below. Failure to
follow these instructions may cause injury or affect the measurement accuracy:
• do not repair and remodel the thermometer;
• avoid contamination of the infrared sensor lens as it may result in
incorrect readings;
• avoid direct finger contact with the lens;
• do not expose the thermometer to extreme temperature, very high
humidity, or direct sunlight;
• avoid extreme shock or dropping the device;
• avoid measuring temperature within 30 minutes after exercise, bathing,
or returning from outdoor;
• dispose of empty batteries at appropriate collection sites according to
national or local regulations;
• it is ill-advised to disassemble the thermometer;
• use the thermometer for the intended purpose only.
8

PREPARATION FOR WORK

Remove the device from the package. Check the battery charge level.
When the battery gets weak, the battery warning symbol appears
possible to measure temperature.
When the battery symbol flashes and «Lo» appears in the display,
the battery must be replaced. If the battery is too flat, then the
thermometer will switch off automatically.
NOTE
• It is recommended to remove the batteries if the thermometer will not be
used for an extended period of time.
• Keep the battery away from children, do not expose to heat.
• Batteries must be disposed of in accordance with local environmental
and institutional policies.
• Do not use rechargeable batteries.
EN
. It is still
55