Agu IHE3 Eaglet Mode D'emploi page 66

Table 2. For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer's declaration – electromagnetic immunity
Infrared thermometer AGU IHE3 is intended for use in the electromagnetic
environment specified below. The customer or the user of Infrared
thermometer AGU IHE3 should assure that it is used in such environment
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage
dips, short
interruptions
and voltage
variations on
power supply
input lines
IEC 61000-4-11
Power
frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE: U – is the AC mains voltage prior to application of the test level.
T
66
IEC 60601
test level
±6 kV (contact)
±8 kV (air)
±2 kV for power
supply lines
±1 kV air for input/
output lines
±1 kV (differential
mode)
±2 kV (common
mode)
<5 % U (>95 % dip
T
in U for 0.5 cycle);
T
40 % U (60 % dip
T
in U for 5 cycles);
T
70 % U (30 % dip
T
in U for 25 cycles);
T
5 % U (>95 % dip
T
in U for 5 sec)
T
3 А/m
Compliance Electromagnetic environment
level guidance
±6 kV Floor should be wood, concrete
(contact) or ceramic tile. If floors are
covered with synthetic material,
±8 kV (air)
the relative humidity should be
at least 30 %
Not Mains power quality should be
applicable that of a typical commercial or
hospital environment
Not Mains power quality should be
applicable that of a typical commercial or
hospital environment
Not Mains power quality should be
applicable that of a typical commercial or
hospital environment.
If the use of Infrared
thermometer AGU IHE3
requires continued operation
during power mains interruptions,
it is recommended that Infra-
red thermometer AGU IHE3 be
powered from an uninterrupt-
ible power supply or a battery
3 А/m Power frequency magnetic
fields should be at levels
characteristic of a typical
location in a typical commercial
or hospital environment