Prior To Initial Use; Operating Instructions; Boiling Water - Beem Tea Joy Royal Plus, KE7903 Mode D'emploi

37. Do not put aluminium between the keep warm plate (9) and the tea pot (10).
This may damage the keep warm plate (9).
PLEASE NOTE: No liability can be accepted for any damage caused by misuse.
5

Prior to initial use

Make sure that any packing material has been removed from outside and inside of
the item (protective film etc).
Check that all parts are there (see chapter 3 "Description and scope of delivery").
Leave the specification plate and any warning notices on the appliance.
ATTENTION: Check the appliance for any damage. If there is any damage, do
not operate it and contact qualified service personnel.
Place the electric base station (7) on a heat/water resistant and flat even surface
Before initial use fill the water boiler (1) with water up to the MAX mark, heat the
water until it has boiled, empty and repeat this procedure. Clean the glass pot (10)
and the tea strainer (11) thoroughly with washing-up liquid in order to remove any
residue from the manufacturing process.
6

Operating Instructions

6.1

Boiling water

Hints and tips:
The water boiler (1) is equipped with a scale filter (14) that holds back scale residues
etc. For cleaning purposes it can be removed by pushing lightly from the inside and
pulling it out.
When the water has cooled down, just push down the on / off switch (6) again and
restart the boiling process.
The switch (6) will automatically shut off if the water boiler (1) is removed from the
base station (7) before or during the boiling process.
Always use non-fizzy, fresh, cold mineral or tap water. Never fill the water tank with
milk, ready coffee, tea etc.
1. Insert the mains cord (15) in the power socket of the base station (7) and then the
mains plug in the household supply.
2. Take the water boiler (1) off the base station, open the lid (2) by pushing the open
button (3) and fill it with the desired amount of water, MAX 1.7 L.
NOTE: If there is too little water the appliance switches off before the water
boils.
ATTENTION: Do not fill the water boiler above the MAX marking. Water may
overflow and the heating element could become damaged. If the water boiler is
overfilled there is the risk of boiling water spurting out.
3. Push the lid (2) down until you hear it click in place.
4. Put the boiler on the base station (7). Due to the 360° rotating system, you can
place it on the base in any position you like.
BEEM – Elements of Lifestyle
Seite/Page/Page/Página
19 / 60