Before First Using This Appliance; How To Use This Appliance - Beem 1003 Mode D'emploi

28. Pull the plug out and allow the utensil to cool before cleaning it.
WARNING of injuries from other causes
29. Do not allow the mains lead to hang over corners (trip-wire effect).
CAUTION – Material damage
30. Never transport the device when it is hot and always only when it is empty.
31. The handles of the container are only for transport purposes.
32. Place the utensil on a flat, heat-resistant, stable surface. Make sure it is a safe
distance away from inflammable parts.
33. The plug must be easily accessible so that you can pull it out quickly if
necessary.
34. Do not place the utensil on a base with a surface which is sensitive to water.
Splashing water could cause damage.
35. Never place the appliance near a gas flame, electric hotplate or other source of
heat. External heat can damage the appliance.
36. The utensil is equipped with a safety device which switches off the heater in
case of overheating or an empty tank. To avoid deactivating this device
accidentally, the utensil may not be operated with a timer or a similar device.
5.

Before first using this appliance

• Ensure that all packaging material has been removed from the appliance (protective
film, etc.).
• Under no circumstances remove the rating label or any warning labels.
CAUTION: check that the appliance is not damaged. If any parts are damaged,
do not use the appliance and contact a qualified service engineer.
• Do not place the appliance beneath an overhanging cupboard.
• Clean the appliance and the accessories before using it for the first time. This will
remove any debris that might remain from the production process.
6.

How to use this appliance

• Pour the required amount of fresh water. Do not fill past the fill level mark.
• Place lid and kettle onto the base unit.
• Ensure that the adjusting knob is turned anticlockwise until it reaches its detent.
• Then insert the plug into the mains socket.
• Turn the adjusting knob clockwise to its detent. The thermostat allows stepless
adjustment of the degree of heat. You can choose between the settings: boil /
interval boil / hot / warm.
• If you turn the adjusting knob to the detent, the water will boil rapidly. If you leave
the adjusting knob in this position, the water will boil continuously until it eventually
all evaporates. To prevent this uninterrupted boiling function, turn the adjusting knob
back until the blue signal light on the base unit goes out. Now the thermostat only
switches on again when the temperature of the water drops, heating it again. In this
way, the thermostat regulates energy supply in accordance with requirements, saving
a great deal of energy. The blue signal light switches on and off in the thermostat
cycle.
BEEM – Elements of Lifestyle 26 / 128