Leds On Battery; Assembling The Blower; Removing And Fitting The Battery; Inserting The Battery - Stihl BGA 86 Notice D'emploi

English
► If the LED on the right flashes green: Charge
the battery.
6.3

LEDs on Battery

The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
17.
Malfunction in blower or battery.
7

Assembling the Blower

7.1 Mounting, Adjusting and
Removing the Nozzle
The nozzle can be mounted to the blower tube in
three positions to suit the height and reach of the
user. The positions are marked on the blower
tube.
► Switch off the blower and remove the battery.
1
2
► Line up the lug (3) and the slot (2).
► Push nozzle (1) into required position on
blower tube (4).
► Rotate nozzle (1) until it engages.
8 Removing and Fitting the
Battery
8.1

Inserting the battery

2
► Insert the battery (1) up to the limit stop into
the battery compartment (2).
20
3
4
1
The battery (1) engages with a click and is
now locked.
8.2 Removing the battery
► Place blower on a level surface.
► Keep one hand in front of the battery compart‐
ment so that the battery (2) cannot fall out.
► Press both locking levers (1).
The battery (2) is unlocked and can be
removed.
9 Switching the Blower
On/Off
9.1 Switching On the Blower
► Hold the blower by the control handle with one
hand, wrapping your thumb around the control
handle.
► Slide the unlocking slide (1) with your thumb in
the direction of the blower tube and keep it
held.
► Squeeze and hold the trigger (2) with your
index finger.
The blower accelerates and air flows out of the
nozzle. The release slide (1) can be released.
The further the trigger switch (2) is depressed,
the more air flows out of the nozzle.
If the ergo lever (3) is pressed, the trigger switch
(2) remains unlocked. This means the trigger can
be released and depressed again without having
to push the release slide in the direction of the
blower tube.
If the trigger switch (2) and the ergo lever (3) are
released, the trigger switch (2) is locked. The
7 Assembling the Blower
1
2
1
3
2
0458-824-9621-B