Safety Recommendations - SKF LAGD 1000 Mode D'emploi

This symbol appears in the manual whenever it is necessary to
draw your attention to special dangers or important actions.
General
The components are designed and manufactured in conformity with the
generally accepted engineering standards as well as applicable industrial
safety and accident prevention regulations. Though constructed to meet
all relevant safety requirements, their use may still entail dangers leading
to personal injury of the user or third parties or damage to property.
Therefore, the components shall only be used when they are in a
technically perfect condition, the operating instructions having to be duly
observed. Any faults, in particular faults, which may affect safety, shall be
rectified without delay.
Use in conformity with intended purpose
The SKF Multipoint automatic lubricators LAGD 1000 are designed for
plant and machine lubrication. They are capable of delivering greases up
to NLGI grade 2. Any other use is not in conformity with the intended
purpose. They must not be used for vehicle lubrication applications.
Approved personnel
The components described in this manual may be installed, operated,
maintained and repaired only by competent personnel in accordance with
local statutory requirements.
Disclaimer of liability
SKF cannot be held liable for any damage caused by;
• Lack of lubricant,
• Contaminated or unsuited lubricants, installation of components or
spare parts other than genuine SKF components or spare parts,
• Any use which is not in conformity with the intended purpose,
• Inappropriate installation and filling, wrong electrical connection,
• Erroneous programming, improper reactions to malfunctioning,
• and non-observance of the instructions for use.
6

Safety recommendations

SKF LAGD 1000