Programming The Lagd 1000/Ac; Changing The Lubrication Interval Times - SKF LAGD 1000 Mode D'emploi

12
13/14
15
4.3 Programming the LAGD 1000/AC.. and LAGD 1000/DC
Read the complete section before programming!
Before programming the LAGD 1000/AC.. or LAGD 1000/DC.., make a note of what you
want to achieve. This makes the process easier to perform.

4.3.1 Changing the lubrication interval times

The following table gives the running time for one internal cycle of the LAGD 1000/AC..
and LAGD 1000/DC.. One internal cycle equates to 0,2 cm
Designation
LAGD 1000/AC10
LAGD 1000/AC12
LAGD 1000/AC14
LAGD 1000/AC16
LAGD 1000/AC18
LAGD 1000/AC20
24
Example: Part 2 of total value
Part 1 of total Total value:
value. 00533,8 h
Note down! Maximum value:
99999,9 h
Indicates fault hours
Example: Part 2 of total value
Part 1 of total Total value:
value. 00033,8 h
Note down! Maximum value:
99999,9 h
LED indicators extinguish
Oh and Fh values are stored in an undeletable way in the
EEPROM
Number of
outlets
10
12
14
16
18
20
per outlet.
3
Running time (tCo) for one
internal cycle of progressive
feeder giving 0,2 cm
(minutes)
1,0
1,2
1,4
1,6
1,8
2,0
/outlet
3
SKF LAGD 1000