Guide Rollers - Husqvarna K6500 II Ring Manuel D'utilisation

2) The drive wheel is worn when the blade edge touches
the bottom of the groove. The blade will slip.
NOTICE! Replace the drive wheel when fitting a new
blade. A worn drive wheel can result in the blade
slipping and becoming damaged.
Inadequate water flow drastically shortens the life of the
drive wheel.
Replacing the drive wheel
• Lock the axle using the locking button.
• Loosen the centre screw and remove the washer.
• You can now lift off the drive wheel.

Guide rollers

Lubricating the guide rollers
• Connect the grease gun to the grease nipples.
24 – English
MAINTENANCE
• Pump in grease until clean grease emerges from the
overflow hole.
Replacing the guide rollers
• Replace the guide rollers when half of the flange on
the rollers is worn.
1) New, 3 mm (0.12'')
2) Worn, ≤ 1,5 mm (0.06'')
• Remove the support roller cover.
• Lift off the blade.