Oceanic OCEACLIM120SR Guide D'utilisation page 55

Remarks:
•
The main control board has a memory function. The main control board
records the previous operation mode before the appliance is put to Sleep
function. Consequently, as you restart the appliance, it will work in the
previous operation mode. It needs not to be reprogrammed. This function
is not available if the previous operation mode is
•
The air conditioner should be used, while under COOL mode or
DEHUMIDIFER function, in locations where windows are closed. Otherwise
the water tank will fill up quickly.
6. Timer
This function is used to program automatic shutdown of the appliance when it
is running, or to program an automatic turn-on.
1. Automatic Off: when the appliance is running, press the
the desired duration after which the appliance will be switched off. Allow the
number of hours on the LED flashes for a few seconds until the timer indicator
light on the left illuminates. Afterwards, the LED will resume displaying the set
temperature.
2. Automatic On: when the appliance is connected to electricity but not turned
on, press the
be turned on. Allow the number of hours on the LED flashes for a few seconds
until the LED goes off, and the timer indicator light on the left remains
illuminating.
The timer can be set between 1 to 24 hours. Press the button "+" or "-" to
increase or decrease the duration. Each press increases or decreases the time
by one hour.
7. Dehumidifier function
When the Dehumidifier mode
bottom will work for 8 minutes then stop for 6 minutes. They will resume
functioning automatically afterwards and repeat the cycle.
Remarks:
•
The fan above will work at a slow speed in Dehumidifier mode (slow by
default). Moderate and fast speed are not supported in this mode.
•
The setting of temperature is not supported in this operation mode.
:
button, set the desired duration after which the appliance will
:
is selected, the compressor and the fan at the
54
.
button and set