Ryobi RY40030 Manuel D'utilisation page 8

À utiliser avec le bloc-moteur de 24 v ry24001 ou de 40 v ry40001b
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 Stop the unit and disconnect the power source when not
in use. Carry the unit with the motor stopped.
 Don't grasp the exposed cutting edges when picking up
or holding the appliance."
 Maintain Appliance With Care - Keep cutting edge sharp
and clean for best performance and to reduce the risk
of injury. Follow instructions for lubricating and changing
accessories. Inspect appliance cord periodically, and
if damaged, have it repaired by an authorized service
facility. Inspect extension cords periodically and replace
if damaged. Keep handles dry, clean, and free from oil
and grease.
 Store out of the reach of children.
 Do not hang unit so that the switch trigger is depressed.
 Battery tools do not have to be plugged into an electrical
outlet; therefore, they are always in operating condition.
Be aware of possible hazards when not using your battery
tool or when changing accessories. Following this rule will
reduce the risk of electric shock, fire, or serious personal
injury.
 Do not charge battery tool in rain, or damp or wet location.
Following this rule will reduce the risk of electric shock.
 Do not use battery-operated appliance in rain.
 Remove or disconnect battery before servicing, cleaning
or removing material from the gardening appliance.
 Use only with battery and charger listed.
• When using with 24 V power head, use 24 V lithium-
ion battery packs. See Tool/Appliance/Battery Pack/
Charger Correlation Supplement 988000-446.
• When using with 40 V power head, use 40 V lithium-
ion battery packs. See Tool/Appliance/Battery Pack/
Charger Correlation Supplement 988000-842.
 Store idle appliances - When not in use, edger should be
stored indoors in a dry, locked place out of the reach of
children.
 Do not dispose of the batteries in a fire. The cell may
explode. Check with local codes for possible special
disposal instructions.
IMPORTANT SAFETY INSTRUCTIONS
 Do not open or mutilate the batteries. Released electrolyte
is corrosive and may cause damage to the eyes or skin.
It may be toxic if swallowed.
 Do not place battery tools or their batteries near fire or
heat. This will reduce the risk of explosion and possibly
injury.
 Batteries can explode in the presence of a source
of ignition, such as a pilot light. To reduce the risk of
serious personal injury, never use any cordless product
in the presence of open flame. An exploded battery can
propel debris and chemicals. If exposed, flush with water
immediately.
 Do not crush, drop or damage battery pack. Do not
use a battery pack or charger that has been dropped or
received a sharp blow. A damaged battery is subject to
explosion. Properly dispose of a dropped or damaged
battery immediately.
 Exercise care in handling batteries in order not to short the
battery with conducting materials such as rings, bracelets,
and keys. The battery or conductor may overheat and
cause burns.
 For best results, your battery tool should be charged in
a location where the temperature is more than 50°F but
less than 100°F. To reduce the risk of serious personal
injury, do not store outside or in vehicles.
 Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in contact
with your skin, wash immediately with soap and water,
then neutralize with lemon juice or vinegar. If liquid gets
into your eyes, flush them with clean water for at least
10 minutes, then seek immediate medical attention.
Following this rule will reduce the risk of serious personal
injury.
 Save these instructions. Refer to them frequently and
use them to instruct others who may use this power tool.
If you loan someone this power tool, loan them these
instructions also.
4 — English

Publicité

Table des Matières
loading

Table des Matières