Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch GSA 1300 PCE Professional Notice Originale

OBJ_BUCH-1366-002.book Page 17 Tuesday, January 25, 2011 11:05 AM

Technical Data

Sabre saw
Article number
Rated power input
Stroke rate at no load
n min
0
Tool holder
Orbital action
Constant electronic
control
Stroke
Cutting capacity, max.
– in wood
– in non-alloy steel
– Pipe diameter
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for a nominal voltage [U] of
230 V. For different voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Noise/Vibration Information

Measured sound values determined according
to EN 60745.
Typically the A-weighted noise levels of the
product are: Sound pressure level 95 dB(A);
Sound power level 106 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Cutting board: Vibration emission value
2
a =21 m/s , Uncertainty K=1.5 m/s
h
Cutting wooden beam: Vibration emission value
2
a =28.5 m/s , Uncertainty K=1.5 m/s
h
Bosch Power Tools
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
GSA 1300 PCE
may be used to compare one tool with another.
Professional
It may be used for a preliminary assessment of
3 601 F4E 2..
exposure.
The declared vibration emission level repre-
W 1300
sents the main applications of the tool. However
if the tool is used for different applications, with
-1
0 – 2900
different accessories or poorly maintained, the
SDS vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
mm 28
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
mm 220
tal working period.
mm 20
Identify additional safety measures to protect
mm 175
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
kg 4.1

Declaration of Conformity

/II
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
25.11.2010
2
,
2
.
English | 17
Dr. Eckerhard Strötgen
Head of Product
Certification
1 609 929 X78 | (25.1.11)