Noise/Vibration Information - Bosch UniversalHedgeCut 50 Notice Originale

12 | English
Hedgecutter
Weight according to
EPTA‑Procedure
01:2014
Protection class
Serial number
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.

Noise/Vibration Information

Noise emission values determined according to EN 60745-2-15.
Typically the A-weighted noise levels of the product are:
– Sound pressure level
– Sound power level
– Uncertainty K
Vibration total values ah (triax vector sum) and uncertainty K determined according to EN 60745-2-15
– Vibration emission value a
h
– Uncertainty K
The vibration level given in these instructions has been
measured in accordance with a standardised measuring pro-
cedure and may be used to compare power tools. It can also
be used for a preliminary estimation of exposure to vibra-
tion.
The stated vibration level applies to the main applications of
the power tool. However, if the power tool is used for differ-
ent applications, with different application tools or poorly
maintained, the vibration level may differ. This can signific-
antly increase the exposure to vibration over the total work-
ing period.
To estimate the exposure to vibration accurately, the times
when the tool is switched off or when it is running but not ac-
tually being used should also be taken into account. This can
significantly reduce the exposure to vibration over the total
working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and application tools, keeping the hands warm,
and organising workflows correctly.
Operation
Pay attention to the mains voltage. The voltage of the
u
power source must match the voltage specified on the
rating plate of the machine.
F 016 L81 787 | (16.08.2019)
UniversalHedgeCut UniversalHedgeCut
50
kg 3.5
/ II
3 600 HC0 500 3 600 HC0 700 3 600 HC0 800 3 600 HC0 900
dB(A)
dB(A)
dB
2
m/s
2
m/s
Switching ON/OFF (see figures C and D)
To switch ON, firstly press and hold the lock-off button for
On/Off switch (3). Then press the On/Off switch (2) and
keep it pressed.
To switch OFF, release the lock-off button for On/Off switch
(3) and then release the On/Off switch (2).
Sawing Function
Although the tooth opening allows wood to be cut up to
Ø 20 mm, the tip of the blade is designed to cut wood up to
Ø 25 mm.
Working with the Hedgecutter (see figure E)
Move the hedgecutter evenly forward along the cutting line.
The double edge cutting blade enables cutting in either dir-
ection, or with a side to side motion.
Cut the sides of the hedge first, then the top.
To cut the sides straightly, we recommend cutting from bot-
tom to top in the direction of growth. Younger stems tend to
move outwards when cutting them from top to bottom, res-
ulting in shallow patches or holes in the hedge.
To reach a level finish, fasten a piece of string along the
length of the hedge at the required height and use as an
alignment guide. Cut the hedge just above the string.
Pay attention that no objects such as wires are cut. The
blade or drive can be damaged.
AdvancedHedgeCut
60 65
3.7 4.0
/ II
see type plate on garden tool
69 69
90 90
1.0 1.0
2.5 2.5
1.5 1.5
AdvancedHedgeCut
70
4.1
/ II / II
71 71
92 92
1.0 1.0
2.5 2.5
1.5 1.5
Bosch Power Tools