Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Press and hold the start button (10)
for at least 5 seconds. The set number
of LEDs will light up to indicate that
the s elected water hardness has been
saved successfully.
Important: If a water filter is used (see
"Accessories"), proceed as follows, see
"Water filter".
Note: If no button is pressed within
90 s econds, the appliance switches to
stand-by mode without saving the new
s ettings. In this case, the previously saved
water hardness setting is retained.
Automatic switch-off
Here you can set the period of time after
which the appliance should switch off
automatically following the last drink
preparation. A time between 15 minutes and
4 hours can be set. To save power you can
specify a shorter period.
1. Turn the rotary
knob (13) to position
2. Press and hold buttons
A
(12) simultaneously for at least
5 seconds. The time after which the
appliance should switch off is indicated
by the number of LEDs that now light up.
3. Now press the start button (10) repeat-
edly until the required number of LEDs
light up to indicate the switch-off time:
D
= 15 minutes
D
E
and
= 30 minutes
D
E
F
,
and
= 45 minutes
D
E
F
,
,
and
D
E
F
G
,
,
,
and
D
E
F
G
,
,
,
,
4. Press and hold the start button (10) for
at least 5 seconds. The set number of
LEDs will light up to indicate that the
selected switch-off time has been saved
successfully.
B
(11) and
G
= 1 hour
H
= 2 hours
H
I
and
= 4 hours
Note: If no button is pressed within
90 s econds, the appliance switches to
stand-by mode without saving the new
s ettings. In this case, the previously saved
switch-off time is retained.
Setting the brewing temperature
The brewing temperature can also be set.
1. Turn the rotary
knob (13) to position
2. Press and hold buttons
A
(12) for at least 5 seconds. The set
brewing temperature is indicated by the
number of LEDs that now light up.
3. Now press the start button (10) repeat-
edly until the required number of LEDs
light up to indicate the temperature:
D
LED
= low
D
E
LED
and
= medium
D
E
LED
,
,and
4. Press and hold the start button (10) for
at least 5 seconds. The set number of
LEDs will light up to indicate that the
selected temperature has been saved
successfully.
Note: If no button is pressed within
90 s econds, the appliance switches to
stand-by mode without saving the new
s ettings. In this case, the previously saved
brewing temperature setting is retained.
Adjusting the grind settings
The selector (3) for grind setting adjusts the
grind settings from coarse to fine.
W Warning!
Adjust the grinding unit only while it is
running! Otherwise the appliance may be
damaged. Do not reach into the grinding unit.
Settings
B
(11) and
F
= high
en
9
Publicité
Chapitres
Table des Matières
