Cleaning The Housing And Nozzles; Storage - DS Produkte VC-S1001 Mode D'emploi

6. Allow all parts to dry completely in the air before you insert them again.
CAUTION! Do not under any circumstances use a hair dryer. Do not insert the
fi lter under any circumstances if it is still damp!
7. Place the fabric tape around the fi lter and close the Velcro fastener.
8. Place the fi lter back into the dust container so that it sits directly on the housing wall all
the way round.
CAUTION! Never use the vacuum cleaner without the fi lter inserted.
9. First place the dust container at the bottom of the device and then fl ip it shut. The dust
container must be fi rmly locked in place at the top and bottom of the device.

Cleaning the Housing and Nozzles

• Clean the housing if necessary using a damp, soft cloth. Dry it with a soft cloth.
• Remove hair and fl uff from the nozzles at regular intervals.

Storage

01328_9_DE-GB-FR-NL_V1.indb 22 01328_9_DE-GB-FR-NL_V1.indb 22
3. Carefully remove the fi lter (5) and empty the dust container.
4. A piece of fabric tape is attached around the fi lter. Open the
Velcro fastener of the tape and gently tap out the fi lter and
the tape.
5. Wash the dust container, the fi lter and the fabric tape if neces-
sary under cold, running water.
CAUTION! Do not wash the fi lter and the fabric tape
in the washing machine.
• If you have attached the telescoping rod (13), you can wind the
cable over the two cable holders (1) for the purpose of storage.
• Store the vacuum cleaner in a cool, dry place which is out of the
reach of children and animals.
22
20.11.12 14:55 20.11.12 14:55