Hitachi DH 25PA Mode D'emploi page 9

Drill bit (Taper shank) and taper shank adapter
Drill bit (Taper shank)
Outer diameter
11.0 mm
12.3 mm
12.7 mm
14.3 mm
14.5 mm
17.5 mm
21.5 mm
13 mm Hammer drill chuck (DH25PB only)
For drilling operations when using a straight shank bit for impact drilling with a hammer drill.
Straight shank bit
(
for impact drill
2. Anchor setting (Rotation + Striking)
Anchor setting adapter (for a rotary hammer)
Anchor setting adapter (SDS-plus shank)
(for rotary hammer)
Overall length: 160, 260 mm
Anchor setting adapter (for a manual hammer)
Taper shank adapter
(SDS-plus shank)
Taper mode
Morse taper (No.1)
Morse taper (No.2)
A-taper
B-taper
13 mm Hammer drill chuck
)
(SDS-plus shank)
Chuck wrench
Anchor size
W1/4"
W5/16"
W3/8"
W1/2"
Anchor size
W1/4"
W5/16"
W3/8"
W1/2"
W5/8"
Cotter
Applicable drill bit
Drill bit (taper shank)
Drill bit (taper shank)
Taper shank adapter formed A-taper or B-taper
is provided as an optional accessory, but the
drill bits for them are not provided.
Anchor setting adapter
(for a manual Hammer)
English
11.0 – 17.5 mm
21.5 mm
8