Installation Instructions - Avantgarde TBWC-46S Manuel D'utilisation

3-PREPARATION & INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler

Remove the exterior and interior packaging.

Before connecting the Wine Cooler to the power source, let it stand upright for approximately 2 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

Install the handle on the door.
INSTALLATION DIAGRAM FOR THE BUILT-IN MODELS
● Level the unit inside the cabinet.
● Open the door of the unit at a 90°angle.
Installation of Your Wine Cooler

This appliance is designed for free standing installation or built-in (fully recessed).

Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded. To level your Wine
Cooler, adjust the front leveling leg at the bottom of the Wine Cooler.

Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.).Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to perform properly.

Avoid locating the unit in moist areas.

Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning about
power and/or grounding should be directed toward a certified electrician or an authorized products service
center.
Reversing the Door Swing of Your Appliance
The door of this appliance has the capability of opening from either left or right side. The unit is delivered to you
with the door opening from the left side. If you desire to reverse the opening direction, please call service center.
(Fees will apply)
6/7/2013
15