Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3-PREPARATION & INSTALLATION INSTRUCTIONS
Before Using Your Wine Cellar
• Remove the exterior and interior packaging.
• Before connecting the Wine Cellar to the
power source, let it stand upright for
approximately 2 hours. This will reduce the
possibility of a malfunction in the cooling system
from handling during transportation.
• Clean the interior surface with lukewarm water
using a soft cloth.
INSTALLATION DIAGRAM FOR THE BUILT-IN MODELS
Level the unit inside the cabinet.
•
Open the door of the unit at a 90° angle.
•
The cutout dimensions are illustrated in figure
•
Installation of your Wine Cellar
This appliance is designed for free standing installation or built-in (fully recessed).
•
Place your Wine Cellar on a floor that is strong enough to support it when it is fully loaded. To level your
•
Wine Cellar, adjust the front leveling leg at the bottom of the Wine Cellar.
Locate the Wine Cellar away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
•
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the unit not to perform properly.
Avoid locating the unit in moist areas.
•
Plug the Wine Cellar into an exclusive, properly installed-grounded wall outlet. Do not under any
•
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
about power and/or grounding should be directed to a certified electrician or an authorized products
service center.
Reversing the Door Swing of Your Appliance
The appliance has the ability of opening from either the left or right side. The unit is delivered to you with the
door opening from the left side. If you desire to reverse the door opening direction, please refer to the included
instructions on the following pages or to our web site at
9/15/2010
www.distributionsavantgarde.ca
18
Publicité
Table des Matières
