Publicité
Les langues disponibles
Les langues disponibles
Adjustment of the cutting height
Follow the adjustment procedure as shown in illustration 5
It is possible to adjust the cutting height on the trimmer head.
There are two different cutting heights on the trimmer. If the
trimmer head is placed on top the cutting height 65 mm if the
head down the cutting height 35 mm
Use an 3 mm Allen wrench
Cleaning
The machine should be cleaned after use. Use a garden
hose to wash off soil and dirt. Remove the trimmer head from
the trimmer axel to remove wedged grass etc. from the rotor
shaft. The chassis number should only be cleaned with a
damp cloth to avoid unnecessary wear. Avoid using a high-
pressure washer during cleaning.
Changing the oil
The oil should initially be changed after the first 5 hours of
use, and thereafter once per year. Use an oil extractor kit.
1. Suck the oil up through the oil filler hole using the
syringe. Use the hose to reach the sump.
2. Transfer the used oil to the container.
3. Fill the engine with new SAE-30 oil.
4. Check the oil level using the dipstick.
Remember to dispose of used oil in a safe way.
Oil and oil extractor kit are not included
Storage
•
If the machine is likely to be stored unused for
prolonged periods, follow the instructions below.
This will ensure longer machine lifetime.
•
Use a garden hose to wash off soil, grass and dirt.
Remove any grass, etc. from the shaft. The chassis
number should only be cleaned with a damp cloth to
avoid unnecessary wear. Avoid using a high-
pressure washer during cleaning.
•
Wipe the machine with a damp cloth so that all
surfaces are clean. Wipe the surfaces down with an
oily cloth to prevent rust.
•
Always store the machine in a dry, clean location.
Troubleshooting
The motor will not start
1. Check the fuel control is set correctly.
2. Check the spark plug.
3. Check there is fresh gas in the tank.
4. See separate motor instructions for further
troubleshooting.
The motor is not running smoothly
1. Ensure the throttle control is not set to max.
2. Check there is fresh gas in the tank.
The trimmer will not rotate
1. Check the cables are in good working order and
fitted correctly.
2. Check and remove wedged grass.
Noise, vibration and precautionary measures
1. Long-term exposure to noise levels exceeding 85 dB
(A) are damaging. Always use ear defenders when
the machine is being used.
2. Reduce the running speed of the motor to reduce
vibration and noise levels.
3. To reduce noise levels further, only use the machine
in an open environment.
4. Vibrations can be reduced further by holding the
handle firmly.
5. To avoid disturbing others, the machine should only
be used during the daytime.
6. Always wear close-fitting work clothes, hard-wearing
work gloves, ear defenders and non-slip boots with
steel toecaps.
7. Take a 30-minute break every 2 working hours.
Specification
Engine
Working width
Working height
Trimmer line
Transmission
Wheels
Adjustable handle
Weight
7
Powerline TG595, 173cc
Max 56 cm
3,5 – 6,5 cm
4 mm
Push
14"
Yes
31 Kg
Publicité
