Assembly; Operation - Husqvarna LC247Li Manuel D'utilisation

• When not in operation, keep the product, battery and
battery charger apart in a dry, indoor and locked
area. Make sure that children and persons that are
Introduction
WARNING: Before you assemble the
product, read the safety chapter.
WARNING: To prevent accidental start
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
To assemble the handle
1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product.(Fig. 20 )
3. Set the handle height in one of the 2 available
positions.
4. Move the knobs up in the direction of the handle until
they stop and you hear a click.(Fig. 21 )
5. Tighten the knobs fully.
To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag.(Fig. 22 )
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To set the product in operation position
1. Fold the handle to upright position.(Fig. 26 )
2. Move the knobs up in the direction of the handle until
they stop and you hear a click.(Fig. 27 )
3. Tighten the knobs fully.
To set the cutting height
The cutting height can be adjusted in 6 levels.
1. Move the cutting height lever rearward to decrease
the cutting height.
2. Move the cutting height lever forward to increase the
cutting height.(Fig. 28 )
12
not approved cannot get access to the product,
battery or battery charger.

Assembly

2. Attach the bottom section of the grass catcher frame
in the groove on the bottom of the grass catcher.
3. Attach the grass bag to the grass catcher frame with
the clips.(Fig. 23 )
4. Lift the rear cover.
5. Attach the grass catcher to the top edge of the
chassis.
6. Put the lower part of the grass catcher into the grass
discharge channel.(Fig. 24 )
To assemble the mulch plug
(accessory)
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the discharge channel.(Fig.
25 )
3. Replace the blade with the mulch blade that is
supplied in the mulch kit. Refer to
247Li, LC 347VLi on page 17 .

Operation

CAUTION: Do not set the cutting height too
low. The blades can hit the ground if the
surface of the lawn is not level.
Battery
WARNING: Before you use the battery, you
must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Battery status
The display shows the remaining battery capacity and if
there are problems with the battery. The battery capacity
is shown for 5 seconds after the product is switched off
or the battery indicator button is pressed. The warning
symbol on the battery is on when an error has occurred.
Battery on page 15 .
See
(Fig. 29 )
Technical data LC
429 - 002 - 13.12.2017