Safety Instructions For Operation; Personal Protective Equipment - Husqvarna LC247Li Manuel D'utilisation

• Use this product to cut grass lawns only. It is not
permitted to use it for other tasks.
• Use personal protective equipment. See
protective equipment on page 10 .
• Do not operate the product in rain or wet conditions.
The risk of electrical shock increases if water enters
the product.
• Do not operate the product unless the blade and all
covers are attached correctly. An incorrectly
attached blade can come loose and cause personal
injury.
• Make sure that the blade does not hit objects such
as stones and roots. This can do damage to the
blade and bend the motor shaft. A bent axle causes
heavy vibration and a very high risk that the blade
becomes loose.
• If the blade hits an object or if vibrations occur, stop
the product immediately. Stop the motor, turn the
safety key to 0 and remove the battery. Examine the
product for damages. Repair damages or let an
authorised service agent do the repair.
• Never attach the motor brake handle permanently to
the handle when the motor is started.
• Put the product on a stable, flat surface and start it.
Make sure that the blade does not hit the ground or
other objects.
• Always stay behind the product when you operate it.
• Let all the wheels stay on the ground and keep 2
hands on the handle when you operate the product.
Keep your hands and feet away from the rotating
blades.
• Do not tilt the product when the motor is started.
• Be careful when you pull the product rearward.
• Never lift up the product when the motor is started. If
you must lift the product, first stop the motor, turn the
safety key to 0 and remove the battery.
• Do not walk rearward when you operate the product.
• Stop the motor when you move across areas without
grass, for example paths made of gravel, stone and
asphalt.
• Do not run with the product when the motor is
started. Always walk when you operate the product.
• Stop the motor before you change the cutting height.
Never make adjustments with the motor started.
• Never let the product stay out of view with the motor
started. Stop the motor and make sure that the
cutting equipment does not rotate.

Safety instructions for operation

Personal protective equipment

WARNING: Read the warning instructions
that follow before you use the product.
• Personal protective equipment cannot fully prevent
injury but it decreases the degree of injury if an
10
accident does occur. Let your dealer help you select
the right equipment.
Personal
• Use heavy-duty slip-resistant boots or shoes. Do not
use open shoes or go with bare feet.
• Use heavy, long pants.
• Use protective gloves when necessary, for example
when you attach, examine or clean the cutting
equipment.
Safety devices on the product
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
Cutting cover
• Examine the cutting cover to make sure that there
are no damages such as cracks.
Safety key
The safety key is below the battery lid. The safety key
connects the battery that supplies the motor with power.
• Start and stop the motor to do a check of the safety
key.
• If the safety key functions correctly, the motor starts
when you turn the key to 1.
(Fig. 17 )
Motor brake handle
The motor brake handle stops the motor. When the
motor brake handle is released, the motor stops.
To do a check of the motor brake, start the motor and
then release the motor brake handle. If the motor does
not stop in 3 seconds, let an approved Husqvarna
service agent adjust the motor brake.
(Fig. 18 )
To examine the start inhibitor
Do a check of the start inhibitor to make sure that it
prevents operation of the motor.
1. Pull the motor brake handle in the direction of the
handlebar. The start inhibitor stops the movement.
2. Push the start inhibitor out.(Fig. 19 )
3. Release the start inhibitor and make sure that it goes
back to its initial position.
WARNING: Read the warning instructions
that follow before you use the product.
429 - 002 - 13.12.2017