Recirculation (Option) - Novy Salsa 6500 Mode D'emploi Et D'installation

3. OPERATION
There is an operating display on the front side of the
hood.
Explanation of operating buttons:
TL T1
TL: lighting
T1: on/off button
T2, T3 and T4: motor speed.
Switch the fan on and off
Press T1 to switch the motor on.
Switching off using a run-out mode
The extractor hood has an adjustable run­out mode. To
select the run­out time, press and hold the TL button
until all the LEDs on the control panel flash. By pressing
one of the buttons (T1, T2, T3, T4) the following run­out
times can be set:
T1: 5 minutes
T2: 10 minutes
T3: 15 minutes
T4: 20 minutes
Switching off without using a run-out mode
Press T1 twice.
Fan speed
The motor has 4 speeds.
The 'POWER' mode (T4) is only used in the event of
strong odour, smoke or vapour being present. Use of
this mode must be kept to a minimum due to the large
flow of air when this mode is selected.
The 'POWER' mode automatically returns to speed
three after 5 minutes.
A self­rectifying thermal contact makes sure that the
motor is switched off when overheated. The motor will
switch on again after is has cooled down. The cause of
the overheating needs to be determined. This may be,
for example, that the contents of the pan have caught
fire, the motor fan is blocked or an object is (partly)
closing off the outlet opening.
Lighting
Press the TL button to switch the LED lighting on or off.
Side exhaust
The hood has been equipped with side exhaust. This
means that the extraction is concentrated on the side
of the hood. This creates a higher air speed on the
sides, which leads to more efficient extraction.
T2 T3 T4
4. MAINTENANCE
Maintenance of the grease filter
4 indicator lamps remain lit
When switching the hood off after 30 hours of cooking
the motor setting indicator lamps remain lit for 30
seconds.
This is the indication that the grease filter needs
cleaning.
Reset grease filter cleaning indication
When the grease filter is replaced after cleaning, simply
keep the T4 button pressed to reset the timer. If you do
not do this, the indicator lamps will remain lit until the
hood is switched off again.
Access to the filter
Take hold of the right and left side of the plate (a) an pull
down simultaneously. Remove the filter (b)
by pushing simultaniously on the 2 fastners.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a liquid de-
tergent. Rince and allow to dry completely
Important! The previous instructions need to be
followed. If not an increased fire hazard may occur.

4.2 Recirculation (option)

Recirculation filter cleaning indicator
Indication: 4 indicator lamps flash
When switching the hood off after 120 hours of cooking
the motor setting indicator lamps keep flashing for 30
seconds.
This is an indication that the fat filter needs cleaning
and the recirculation filters need to be replaced. =
Reset recirculation filter cleaning indication
When the fat filter and the recirculation filters are
replaced after cleaning, simply keep the T4 button
pressed to reset the timer. If you do not do this, the
indicator lamps will keep flashing until the hood is
switched off again.
EN 12