Installing The Line Cell; Installation Of The T-Cell - Norsup UNO Notice Originale

SALT CHLORINATOR
17-A 17-B
3) Prepare the 2 connectors and following
the direction of assembly of the parts shown below.
ATTENTION
Respect the direction of the arrow engraved on
each fitting.
4) Mount the 2 connectors 17-A / 17-B and the 2 valves
22 8
in the 2 saddle clamps in accordance with the
image shown opposite, using Teflon tape.
ATTENTION
17-A 17-B
Do not invert the connectors and
during assembly: observe the installation
diagram shown on the previous page,
following the direction of the water flow.
16 WWW.NORSUP.EU
6
5) Fix measuring chamber to the wall using the
screws and plastic anchors provided.
6
6) Connect measuring chamber to the 2 connectors
17-A 17-B 21
and , with the semi-flexible tubing cut
to the right size.
19
7) Remove the storage vial from ORP probe .
A
8) Loosen nut (see the image shown opposite)
without removing it.
19
9) Insert the probe into the measuring chamber
as in the photo below.
A
10) Tighten nut by hand.
Alterations which serve the technological progress as well as errors excepted!
SALT CHLORINATOR

7.10. INSTALLING THE LINE CELL

6
1) If pipe A has an outer diameter of 50 mm, cut the
pipe to a length of 248 mm.
If pipe A has an outer diameter of 63 mm, cut the
pipe to a length of 232 mm.
2) Fully disassemble the cell following the above
exploded diagram.
3) Rub down all bonding surfaces with sand
A C
paper: pipes , reducers , collars
B
4) Slide each nut onto the end of each
A
pipe .
5) Glue together each set of [pipe
reducer C - collar D ].
6) Wait for the glue to dry completely.
E
7) Place each seal inside each collar
F
8) Attach cell with the 2 nuts
ATTENTION
Screw on and tighten nuts B
Alterations which serve the technological progress as well as errors excepted!

7.11. INSTALLATION OF THE T-CELL

1) Fully disassemble the cell following the exploded
diagram above.
2) Rub down all bonding surfaces with sand paper:
A B
pipes , reducers
D
.
3) Glue together the unit comprising
A
[pipes - reducers
4) Wait for the glue to dry completely.
A
-
5) Place seal D all the way into electrode
E
6) Slide electrode into sleeve
the electrode aligned as in the above diagram.
D
.
F
7) Screw nut onto sleeve
B
.
ATTENTION
F
Tighten nut by hand.
by hand.
EN
DE
FR
ES
PT
IT
C
, sleeve .
B C
- sleeve ].
E .
C
, with the plates of
C
.
ORIGINAL MANUAL NORSUP 17