Orp Measuring Heat Contactor Installation (Pro) Model Without The Optional Measuring Kit; Installation Of The Orp Measuring Heat Contactor (Pro Model) - Norsup UNO Notice Originale

SALT CHLORINATOR
3) Check that there are no air bubbles inside the bulb.
If this is not the case, shake the probe by holding the
bulb downwards until the air bubble has risen into the
body of the probe.
4) Following the image and the instructions shown
opposite:
a) With the use of sealing tape (not supplied), screw
the probe connector 16
into the accessories
15
holder and tighten by hand.
b) Loosen nut A without removing it.
20 16
c) Insert pH probe into probe holder .
ATTENTION
• Do not push the probe as far as the stop-point
of the pipe. Place the probe halfway up accessories
15
holder .
• The probe must be installed:
- after the filter and before any treatment device,
- on the top of the pipe,
- vertically, and on the level (not tilted).
A
d) Tighten nut by hand.
14 WWW.NORSUP.EU
7.8. ORP MEASURING HEAT CONTACTOR INSTAL-
LATION (PRO) MODEL WITHOUT THE OPTIONAL
MEASURING KIT
1) Mount the saddle clamp 8 on the pipe, as shown in
the image opposite.
2) Drill the top of the pipe through the hole of the
saddle clamp (see arrow opposite), taking care not
to damage the tapping.
19
3) Remove the storage vial from ORP probe .
Alterations which serve the technological progress as well as errors excepted!
SALT CHLORINATOR
4) With the use of sealing tape (not supplied), screw
16 8
the probe connector into the saddle clamp
and tighten by hand, as shown in the photo
opposite.
A
5) Loosen nut without removing it.
6) Insert probe 19 into probe holder 16 as shown in the
image opposite.
ATTENTION
Do not push the probe as far as the stop-point of the
pipe. Place the probe halfway up the pipe.
A
7) Tighten nut by hand.
7.9. INSTALLATION OF THE ORP MEASURING HEAT
CONTACTOR (PRO MODEL) WITH THE
OPTIONAL MEASURING KIT
Alterations which serve the technological progress as well as errors excepted!
1) Mount the 2 saddle clamps 8 on the pipe, as shown
in the image opposite.
2) Drill the top of the pipe through the hole of the
saddle clamps (see arrow opposite), taking care not
to damage the tapping.
ORIGINAL MANUAL NORSUP
EN
DE
FR
ES
PT
IT
15