Electrical Connections - Norsup UNO Notice Originale

SALT CHLORINATOR

7.12. ELECTRICAL CONNECTIONS

AC: Power cable connection for electronics unit (220 V
- 50/60 Hz).
ATTENTION
• Before connecting the power cable to the
electronics unit, make sure that the electrical
installation complies with the standards and
regulations in force in the country of installation.
• The connection must be carried out by a qualified
electrician.
• Do not use an extension cord.
• Do not connect the electronics unit to an
electrical outlet.
• Disconnect the power supply at the circuit
breaker beforehand and make sure that the
power supply is switched off using suitable tools.
ATTENTION
Permanently connect the electronics unit to the
electrical unit, by linking it to the filtration pump
contactor. (Reminder: A sufficient flow of water
must be maintained in the electrolytic cell when
connected to a power supply).
18 WWW.NORSUP.EU
NOTE
1 2
The drawer contains a fuse (6.3 A time-delay
fuse - 5 x 20 mm, as well as a compartment to
3
store a spare fuse (not provided):
Alterations which serve the technological progress as well as errors excepted!
SALT CHLORINATOR
ORP - CL:
ORP probe connection.
S/T° - FLOW:
- Connection for salt/temperature/low-water sensor.
- It is also possible to connect a flow sensor.
→ To connect a flow sensor, use the adaptor supplied with it.
COV - EXT:
Connection for a flap position switch.
→ Use the connector below provided:
Directly insert the cables of the position switch into terminals
(To remove the cables, apply pressure to the strips 5 using a flathead screwdriver.)
PH:
pH probe connection.
CELL: Connection for the cell using the corresponding power cable.
Alterations which serve the technological progress as well as errors excepted!
4
.
ORIGINAL MANUAL NORSUP
EN
DE
FR
ES
PT
IT
19