Positioning The Unit; Before Using For The First Time - SEVERIN MW 7829 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
Dear Customer
Before using the appliance, please read the following instructions carefully and keep this
instruction manual for future reference. The appliance must only be used by persons familiar
with these instructions,
1. Viewing window
2. Door locks
3. Door handle
4. Protective cover
5. Grill element
6. Interior light
7. Display
Always place the microwave oven on a stable, level and heat-resistant surface, ensuring
that it is protected from any heat source or excessive humidity.
Do not operate the appliance outdoors.
Sufficient ventilation must be ensured at all times. Do not place any objects on the unit,
and make sure that the following minimum distances from any wall or other object are
maintained:
Side:
5 cm
Rear:
10 cm
Top:
20 cm
The feet on the base of the unit must not be removed.
The unit must not be installed inside a cupboard; when positioning the unit, also ensure
that it is not placed directly underneath a cupboard or any other similar object.
Connection to the mains supply
The appliance should only be connected to an earthed socket installed in accordance with
the regulations. Make sure that the supply voltage corresponds with the voltage marked on
the rating label. This product complies with all binding CE labelling directives.
Remove any exterior and interior packaging materials. All these materials are suitable
for recycling.
After unpacking and every time before connecting the unit to the power supply, check
the unit and its power cord carefully for any signs of damage. Also ensure that the door,
including the viewing window and door locks, are not damaged or bent and that it closes
firmly against the support. This is important to ensure that no microwave energy is
allowed to escape during operation. For the same reason, the entire casing as well as the
inside of the oven must be carefully checked.
Should the unit show any signs of damage, it must not be used under any circumstances
Familiarisation

Positioning the unit

Before using for the first time

8. Control panel
9. Rotary control
10. Glass turntable
11. Roller ring
12. Drive unit
13. Grill rack
17

Publicité

Table des Matières
loading

Table des Matières