Positioning The Unit; Before Using For The First Time - SEVERIN MW 9675 Mode D'emploi

1. Door handle
2. Door locks
3. Inspection window
4. Grill element
5. Protective cover
6. Interior light
7. Display
Always place the microwave oven on a stable, level and heat-resistant surface, ensuring that it is
protected from any heat source or excessive humidity.
Do not operate the appliance outdoors.
Sufficient ventilation must be ensured at all times. Do
not place any objects on the unit, and make sure that
the following minimum distances from any wall or
other object are maintained:
One side: 7.5 cm; other side unobstructed
Rear: 7.5 cm
Top: 30.0 cm
The feet on the base of the unit must not be
removed.
The unit must not be installed inside a cupboard; when positioning the unit, also ensure that it
is not placed directly underneath a cupboard or any other similar object.
Connection to the mains supply
The appliance should only be connected to an earthed socket installed in accordance with the
regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating
label. This product complies with all binding CE labelling directives.
Remove any exterior and interior packaging materials. All these materials are suitable for recycling.
Do not remove the grey-brown protective cover (5) next to the light on the right of the interior.
Caution: Keep any packaging materials well away from children, as they are a potential source
of danger e.g. from suffocation.
After unpacking, and every time before connecting the unit to the power supply, check the unit
and its power cord carefully for any signs of damage. Also ensure that the door, including the
inspection window, door seals and locks, are not damaged or bent and that it closes firmly
against the support. This is important to ensure that no microwave energy is allowed to escape
during operation. For the same reason, the entire casing as well as the inside of the oven must be
carefully checked.
Should the unit show any signs of damage, it must not be used under any circumstances until
it has been repaired by a qualified technician.
Familiarisation

Positioning the unit

Before using for the first time

16
8. Operating buttons
9. Rotary control
10. Glass turntable
11. Roller ring
12. Drive unit
13. Grill rack