Télécharger Imprimer la page

Siemens TE803 Série Mode D'emploi page 29

Masquer les pouces Voir aussi pour TE803 Série:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
Problem
The coffee grounds are
not compact and are too
wet.
Water dripped onto the
inner floor of the appli-
ance when the drip tray
was removed.
The water filter does not
stay in position in the
water tank.
Display shows
Refill bean container
although the bean
container 15 is full, or the
grinding unit does not
grind the beans.
Display shows
Clean brewing unit
Display shows
Check water tank
Display shows
Restart appliance
Display shows
Error
Please contact hotline
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
Cause
The grinding setting is too
fine or too coarse, or not
enough ground coffee has
been used.
Drip tray removed too
early.
The water filter is not
mounted correctly.
Beans are not falling into
the grinding unit (beans too
oily).
Brewing unit is soiled.
Too much pre-ground
c offee in the brewing unit.
The brewing unit's
m echanism is stiff.
Water tank wrongly
inserted.
Carbonated water in the
water tank.
Float is stuck in the water
tank.
New water filter not
rinsed according to the
instructions.
Air in the water filter.
Water filter is old.
Appliance is too warm.
Brewing unit is soiled.
The appliance has a fault.
Simple troubleshooting
Solution
Adjust the grinding unit to a
coarser or finer setting, or use
2 level measuring spoons of
ground coffee.
Wait a few seconds after the
last drink was dispensed before
removing the drip tray.
Firmly press the water filter
straight down into the tank
connection.
Gently tap the bean container 15.
Change the type of coffee if
n ecessary. When the bean
c ontainer 15 is empty, wipe it
with a dry cloth.
Clean brewing unit.
Clean brewing unit (pour in no
more than 2 level measuring
spoons of ground coffee).
Clean brewing unit (see "Mainte-
nance and daily cleaning").
Insert water tank correctly.
Fill the water tank with fresh tap
water.
Remove the tank and clean
thoroughly.
Rinse the water filter according
to the instructions and then
switch on.
Dip the water filter into water
until no more air bubbles
escape; insert the filter again.
Insert a new water filter.
Leave the appliance to cool
down.
Clean the brewing unit.
Please contact the hotline.
en
25

Publicité

loading

Ce manuel est également adapté pour:

Te806 série