Assembly Instructions - Franke AQUATIMER A3000 7612982131844 Notice De Montage Et De Mise En Service

11. Assembly Instructions

Warning!
Use the fitting only with non-return valves and the grit filters specified.
Failure to observe can result in an increased bacterial load in drinking water and cause
a health risk or even risk of death.
Warning!
• Operate the product only with safety extra low voltage (SELV). Do not earth the
components.
• The power supply (not included in the scope of delivery, see accessories,
Chapter 24) must be set up outside of the wet area, in a separate room.
• Secure the electric connection with an earth leakage circuit breaker (RCD).
Failure to observe can mean risk of death or material damage, e. g. from electric shock
or fire.
☞
Important!
Before installing, flush the pipes in compliance with DIN 1988.
☞
To protect the tiles, use masking tape when marking and drilling. Drill at low speed.
☞
Depending on the composition of the wall, special wall dowels may have to be used (to
be provided by the customer).
☞
The system line (not included in scope of delivery) for connecting the power supply to
the fittings must be installed in a conduit (to be supplied by customer) and looped
through.
Installing the Electric T-junction
☞
Important!
The components of the electronic T-junction must be installed only when they are in a
dead condition.
☞
Recommended system lines see
When using other cables for the system line, note the different colour coding. The outer
diameter must not exceed 7.5 mm.
Fig. A: Water connection from above
Fig. B: Water connection from rear
11.1 Only when the water connection is from the rear: Install the connection bracket (a)
leaktight.
11.2 Screw in the water volume regulators (b) leak-tight.
11.3 Align the water volume regulator in such a way that the screw plug and the operating
element are freely accessible.
11.4 For a shower head height of 2.10 m to 2.30 m, mark drill holes for installation at a
height (c) of 2.14 m to 2.34 m from the upper edge of the prefabricated foot base.
11.5 Drill according to the markings.
11.6 Insert the dowels.
11.7 Screw on the hook-in strip.
11.8 Hook-in the stainless steel housing.
Chapter 24., Accessories.
7