Before First Use; Replacing Battery; Operation; Weighing - SilverCrest HG01696B Instructions D'utilisation Et Consignes De Sécurité

Risk of damage of the
product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before
inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.

Before first use

Q
Note: Remove all packaging materials from the
product.
1. Turn the product over and place it on a soft
underlay to avoid scratching the surface.
2. Loosen the screw located at the battery
compartment cover
product by using a screw driver.
3. Open the battery compartment cover
4. Remove the insulating strip from the battery
compartment .
7
5. Close the battery compartment cover
tighten the screw by using a screw driver.

Replacing battery

Q
1. Turn the product over and place it on a soft
underlay to avoid scratching the surface.
18 GB/IE
on the back of the
8
.
8
and
8
2. Loosen the screw located at the battery compart-
ment cover on the back of the product by
8
using a screw driver.
3. Open the battery compartment cover
4. Remove the used battery from the battery com-
partment by gently pulling the grip
7
outwards. Make sure that you do not exert too
much pressure on the grip
wise be damaged.
Remove the battery from the battery compart-
ment .
7
5. Insert the new battery (as specified in section
„Technical data"). Make sure that the polarity is
correct. The battery must be pressed inside the
battery holder.
Note: Make sure you insert the battery with
the correct polarity. This is indicated in the bat-
tery compartment cover
6. Close the battery compartment cover
tighten the screw by using a screw driver.

Operation

Q

Weighing

Q
Note: Starting with or without the weighing
bowl , the product always starts at 0 g / 0.0 oz
1
(the temperature will also be shown) when you
switch it on.
However, if you place the weighing bowl
the product after you have switched it on, the
product will indicate the weight of the weighing
bowl . Press the Zero button
1
play to 0 g / 0.0 oz. The product now reads "TARE".
Place the weighing bowl
Press the ON / OFF button
product on.
Select the unit of weight by pressing the unit of
weight button . You can choose between
5
"g / kg" and "oz / lb".
Place the food you wish to weigh in the weigh-
ing bowl .
1
The LCD readout
4
food in the selected unit of weight.
.
8
9
or it may other-
9
.
8
and
8
on
1
to reset the dis-
6
on the product.
1
to switch the
2
indicates the weight of the