Before First Use; Initial Use; Replacing The Battery; Setting The Units Of Weight - SilverCrest SPW180 1 Mode D'emploi

Before first use

Remove all packaging materials from the
product.
Initial use (see Fig. H)
1. Turn the product over and place it on a soft
underlay to avoid scratching the surface.
2. Open the battery compartment
of the product.
3. Remove the insulating strip under the battery.
4. Reattach the battery compartment cover
the battery compartment

Replacing the battery

(see Fig. H)
1. Turn the product over and place it on a soft
underlay to avoid scratching the surface.
2. Replace the battery when the product is not
in use.
3. Open the battery compartment cover
described in chapter "Initial use".
4. Remove the battery from the battery compart-
ment .
4
Note: The LC display
replace the battery. When standing on the pro-
duct if the battery is low, the LC display
display "Lo" (see Fig. C) and the product will
automatically switch off.
Note: When the product displays "Lo", replace
the drained battery with a new battery of the
type specified under "Technical data".
5. Insert a new battery in the battery compartment
. Be sure to insert the battery correctly, with
4
the "+" pole up.
6. Close the battery compartment
in chapter "Initial use".
16 GB/IE
at the back
4
to
5
.
4
as
5
will show then to
1
will
1
as described
4

Setting the units of weight

Note: The standard unit of weight is kilogram (kg).
The factory default setting for the product as sup-
plied is "kg".
Press the kg / lb / st button
of weight. The units will be displayed in the
LC display as follows:
1
Kilogram (kg): see Figure A
Pound (lb): see Figure E
Stone (st): see Figure F
Switching on your product /
measuring your weight
Tip: Weigh yourself at the same time of day
(preferably in the morning) after visiting the toilet,
with an empty stomach and without clothing to
ensure that your results are compatible.
Place the product down on a solid, flat horizon-
tal surface.
Step on to the product.
Place even weight on each leg.
If at all possible stand on the same areas of the
platform each time and do not move. Moving
during the weighing process can lead to dis-
crepancies in the results.
The product will start to measure immediately.
After blinking 3 times, the weight display will
display the result, as shown in, for example, Fig. B.
Note: If the product shows "oL" (see Fig. D), it
signals that the product is overloaded. Observe
the maximum capacity of 180 kg (396 lb / 28 st).
Step off the platform
off automatically after about 10 seconds. Until
then the weight measurement remains visible.
Note: After a change of location and follow-
ing every battery change, the product must be
re-calibrated. To do this, proceed as follows:
Step onto the product. The product will show
you an incorrect measuring result. Step off the
platform . The product will calibrate auto-
2
matically.
to select the unit
3
. The product switches
2