First Use; Wi-Fi Connection Via Wps; Connect Wi-Fi Via Lifestream Ii - Medion LIFE P61071 Mode D'emploi

10. First use

• When using the Wi-Fi speaker for the first time, place it as close as possible to
the router to ensure a perfect signal during set-up. Later, you can place the Wi-Fi
speaker anywhere within range of the Wi-Fi signal.

10.1. Wi-Fi connection via WPS

If your router has a WPS button, you can establish the connection to the speaker
simply by using this button:
 Press the WPS button on the rear of the Wi-Fi speaker for about 3 seconds.
 Now press the WPS button on the network router.
NOTICE!
Please also refer to the instructions for the router.
The device will now establish a connection with the network. While this happens,
the operating LED will flash rapidly.
• Once the connection has been successfully made, the operating LED will light
up permanently white.
• The device can now play back audio signals from the network.
• The device saves the connection data so that it does not need to be entered
again the next time you switch on the speaker.

10.2. Connect Wi-Fi via Lifestream II

If it is not possible to set up the network connection via WPS, use the app
LIFESTREAM II on your smartphone or tablet to set up a connection to the In-
ternet and the Wi-Fi speaker.
 Switch the Wi-Fi speaker on. The operating LED flashes white. If the operating
LED does not flash white, then press the MODE button and keep the MODE
button pressed until the operating LED flashes white.
 Start the selected app, tap on "SET UP AUDIO SYSTEM" and follow the in-
structions.
 Select the suggested audio system "MEDION XX-XX-XX" and tap on Next.
 Follow the on-screen instructions.
Once the set-up of the Wi-Fi speaker, and thus the connection of the Wi-Fi speak-
er to the Internet, has been successfully completed, the operating LED will light up
permanently white.
30