Sleep Mode - Hach DR 3900 Manuel D'utilisation De Base

Self-check
Each time the instrument is powered up, a test program begins.
This procedure, which takes approximately two minutes, checks the
system, lamp, filter adjustment, wavelength calibration and voltage.
Each test that functions correctly is marked accordingly.
The Main Menu is displayed when diagnostics are completed.
Note: In the event of further error messages during the test program,
refer to Troubleshooting, page
English 12
19.

Sleep mode

The instrument can be put into sleep mode.
Briefly press the power button next to the display.
1.
The "Sleep mode" message is shown. The display will then switch
off automatically.
To switch on, press the power button next to the display.
2.
The self-check will start automatically.
After that, the instrument is ready to use.
Power off the instrument
Press the power button next to the display for approximately
1.
5 seconds.