Technical Data; Service Department - Elem Garden Technic MTBE302T Traduction Des Instructions D'origine

Maintenance
Disconnect the mains plug
before performing all
Risk of injury to persons and damage to
property.
V Never clean the Electric Hoe with running
water,
in particular with water under high pressure.
The gearbox may be very hot during and after
use.
V Wear gloves when performing maintenance
work.
The Electric Hoe is mainly maintenance-free.
Make sure the vents I located on the engine block
are never dirty and clogged.
1. Remove any remaining dirt or other debris vents
with a dry cloth or brush. Do not forget to clean the
guard.
2. Clean the blades and drive shaft L and grease
them with a biodegradable oil
Caution! There is a risk of injury
when the blades are not in
accordance with the appliance!

TECHNICAL DATA

Mains voltage V
Mains frequency Hz
Power input W
No load speed min-1
Working width mm
Working mm
Number of Blades
Weight kg
Acoustic pressure level
LpA 68,7 dB(A) K = 3 dB(A)
Acoustic power level
LwA 88,7 dB(A) K = 3 dB(A)
Guaranteed sound power LWA 93 dB (A)
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard. : 1,328 m/s² K= 1.5 m/²
Warning!
maintenance work.
230
50
300
280
162
150
4
4,82
ATTENTION !
must be worn.
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).

SERVICE DEPARTMENT

_ Damaged switches must be replaced by our after-
sales service department.
_ If replacing the power cord is necessary, it
should be done by the manufacturer or his agent
to avoid a hazard.
After-sales Service and Application Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product
as well as spare parts. Exploded views and
information on spare parts can also be found
under:www.eco-repa.com
ELEM GARDEN TECHNIC application service team
will gladly answer questions concerning our
products and their accessories : sav@eco-repa.com
STORAGE
Store your Electric Hoe away
_ Thoroughly clean the whole machine and its
accessories.
_ Store it out of the reach of children, in a stable and
secure position, in a cool and dry place, avoid too
high and too low temperatures.
_ Protect it from exposure to direct sunlight. Keep it
in the dark, if possible.
_ Don't keep it in plastic bags to avoid humidity
build-up.
At the end of the season, perform a general
inspection of the machine and remove any deposits
which may have accumulated. At the start of each
season, ensure that you check the condition of the
machine. If repairs are necessary, please contact
one of our customer service centers (see address
on warranty certificate).
Risk of fire !
from fuels, oils,
grease and gases.
21