Cleaning And Maintenance; Service Department; Technical Data; After-Sales Service And Application Service - Elem Garden Technic ASB3001-18 Instructions D'origine

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTRUCTIONS FOR USE
_
Connect the appliance to a suitable extension
cord.
_
Hold the appliance with both hands.
_
Slowly move the appliance back and forth.
_
Keep the wheels on the ground during use to
reduce the workload.
When operating, always hold the machine close to
the ground.
Do not blow hot, flammable or explosive material.
The garden vacuum is only suitable for foliage and
garden waste.
Please inspect the area for little animals and hard
objects before using the tool.
Do not vacuum liquids, plastic bags, cans, pine
cones, branches larger than 5 mm, cloth, tissues
and pegs.
SWITCHING ON AND OFF
To switch on the blow/vac push in the on/off trigger
switch (2). And hold
to switch off the machine, release the on/off trigger
switch.

CLEANING AND MAINTENANCE

Check the blower vac for any signs of damage
before each use.
After using the machine
1. Empty the leaf bag.
2. Check the vacuum tube and remove leaf residue.
3. Check the blower vac's slide control for leaf
residue.
4. Clean the machine with a soft dry cloth.
5. Store the machine in a safe place where it is out
of the reach of children.
If the device can not be started or continues to
malfunction, you need to check and repair the
device by a Service Centre.

TECHNICAL DATA

Mains voltage
V
Mains frequency
Hz
Power input
W
No load speed
min
max airspeed
Km/h
m³/min
Mulching
dust bag
L
Int. protection
IP
degree
Weight
kg
ASV3001-18
230-240
50
3000
-1
14000
270
13.2
35
10 :1
20
2.7
Acoustic pressure level
L
84.1 dB(A)
PA
Acoustic power level
L
95.8 dB(A) K = 2.21 dB(A)
WA
Guaranteed sound power level
L
102 dB(A)
WA
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard. :
7.490 m/s²
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).

SERVICE DEPARTMENT

_ Damaged switches must be replaced by our after-
sales service department.
_ If replacing the power cord is necessary, it
should be done by the manufacturer or his agent
to avoid a hazard.
AFTER-SALES SERVICE AND
APPLICATION SERVICE
Our after-sales service responds to your questions
concerning maintenance and repair of your product
as well as spare parts. Exploded views and
information on spare parts can also be found
under:www.eco-repa.com
ELEM GARDEN TECHNIC application service team
will gladly answer questions concerning our
products and their accessories : sav@eco-repa.com
K = 3 dB(A)
ATTENTION !
must be worn.
K = 1,5 m/s².
21

Publicité

Table des Matières
loading

Table des Matières