Safety Instructions For The Use Of The Product; Particular Types Of Dangers; Maintenance, Service And Troubleshooting; Warranty And Liability - ABNOX AXFP 1 Série Instructions De Service

Safety Instructions for the Use
of the Product
All parts and assembly groups have been developed
and constructed in accord with the recognised rules
of safety engineering. However, if it is handled or
operated improperly, this can result in dangers to the
user or third parties or hazards to the product or to
their property.
The product must only be used:
• For its intended purposes.
• In a proper condition in terms of its safety enginee-
ring features.

Particular Types of Dangers

Electrical Energy
ELECTRICAL VOLTAGE
Warning about electrical hazards
that can lead to bodily injury and/or
property damage.
Hydraulic and Pneumatic Energy
HYDRAULIC AND PNEUMATIC
SYSTEMS
Warning about hydraulic and
pneumatic hazards that can lead
to bodily injury and/or property
damage.
Hazards from hydraulic and pneumatic energy
The product works, depending on configuration, with
high hydraulic and pneumatic pressure (see technical
information). System sections such as pressure lines,
valves or consumers that must be opened must first
be depressurised before the start of repairs. There
may be no residual pressure.
Hazards from lubricants
The safety instructions form the lubricant manufac-
turer must be heeded and its instructions strictly follo-
wed. The manufacturer of this product rejects any
liability for incidents that result from failure to follow
the rules, instructions and recommendations of the
lubricant manufacturer.
Maintenance, Service and
Troubleshooting
• Prescribed calibration and maintenance work
following the maintenance schedule must be
completed in a timely fashion.
• Inform the operating personnel prior to any
calibration or maintenance work.
• Turn off the main switch (if there is one).
• Disconnect the energy supply from the main net-
work and secure against unintentional reactivation.
• Pneumatic and/ or hydraulic systems must be
de-pressurised.
• Check all screw connections and armatures for
proper fit.
• Once all work is completed check all safety
equipment and operational functions.
CAUTION
Any and all work on the product
may only be carried out when it is
idle.
ENVIRONMENTAL HAZARDS
The various materials/liquids are to
be handled properly and separately
disposed of in compliance with the
applicable national regulations.

Warranty and Liability

Warranty and liability claims are excluded in cases of
personal injury and property damage if they derive
from one or more of the following causes:
• Improper use of the product.
• Work completed by unqualified persons.
• Improper transportation, storage, assembly,
operational start-up, operation and maintenance of
the product.
• Failure to heed the instructions in the Operating
Manual regarding safety, transport, storage, assem-
bly, operation, operational start-up, maintenance
and equipping the product.
• Operating the product if safety equipment is
defective or not properly installed or if the safety
and protective equipment is not functional.
• Structural modifications to the product.
• Changing the pressure ratios in the pressure safety
and operating at pressures higher than those for
which the product is designed.
EN
19