Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 1: Lower Support Assembly
Select:
• 2 Lower Supports (item 1)
• 2 Support Spacers (item 2)
• 4 1/2" x 2" (1.3 x 5 cm) Bolts (item 7)
1) Make sure you have removed the tie rods from inside the
support spacers.
2) Fasten one support spacer to lower support section with
1/2" (1.3 cm) Bolt as shown in the adjacent photograph.
After orienting the other lower support section in
a position where the straight and smaller ended
uprights are diagonally opposite each other, fasten
this section to the opposite end of the support spacer
with 1/2" (1.3 cm) bolt.
3) With lower support sections held upright, as above,
fasten the other support spacer in a similar manner with
2 additional 1/2" (1.3 cm) Bolts to form the assembly
shown in the adjacent photograph.
STEP 2: Upper Support Assembly
Select:
• 2 Upper Supports (item 4)
• 2 Support Spacers (item 2)
• 4 1/2" x 2" (1.3 x 5 cm) Bolts (item 7)
1) With open end facing down, position one upper support,
parallel to a lower support spacer, over the upright
sections of the lower support assembly, and oriented so
that a small diameter end opposes a straight section.
(Note: Upper support sections (item 4 in adjacent photo)
must be at right angles to lower support sections (item
1 in adjacent photo) to result in sufficient strength and
stability to support the drum.)
2) Slip the ends of the upper support fully into and over the
uprights of the lower support section. Repeat with the
second support.
3) Fasten the support spacers to the upper supports,
following the same procedure used in Step 1.
4) Now is the time to secure the 8 bolts that turn into the
support spacers. Using a 3/4" (19 mm) wrench, snugly
tighten each bolt to stabilize support frame.
4
Publicité
Table des Matières
