Glossary Of Terms - Konect PRODUO 80 Manuel D'utilisation

VOL SELECT ERR
VOL SELECT ERR
BREAK DOWN
BATTERY CHECK
LOW VOLTAGE
BATTERY CHECK
HIGH VOLTAGE
BATTERY VOLTAGE
CELL LOW VOL
BATTERY VOLTAGE
CELL CONNECT
BATTERY VOL ERR
CELL HIGH VOL
TEMP OVER ERR
CONTROL FAILURE

GLOSSARY OF TERMS

• Amps(A): The unit of measure for charge or discharge electric current. The program of the charger will
show most of the current in amps(A) at its LCD screen.
• Milli-amps(mA) : The electric current, being amps(A) multiplied by 1000 and noted as "mA". So 2.0A
is the same as 2000mA (2.0*1000). Or, to convert mA to amps, divide the mA number by 1000. So
200mA is the same as 0.2A. If a current value is below 1.0A, the LCD screen of the charger will still
show the current in amps, not milli¬amps. For example, a current of 600mA will be displayed as 0.6A,
and a current of 100mA will actually be shown as 0.1A.
• Capacity, milli-amp hours (mAh), and amp-hours (Ah): Charge energy stored by a battery is called
capacity, which is defined as how much current a battery can supply constantly over one hour of time.
The voltage of input power lowers the limit.
The voltage of Lithium battery pack was selected incorrectly. Verify the
voltage of battery pack carefully.
There happens malfunction at the charger circuit by any reason.
The processor detects the voltage is lower than you set at Lithium program.
Please check the cell count of the cell one by one.
The processor detects the voltage is higher than you set at Lithium program.
Please check the cell count of the cell one by one.
The voltage of one of the cell in the Lithium battery pack is too low. Please
check the voltage of the cell one by one.
The voltage of one of the cell in the Lithium battery pack is too high. Please
check the voltage of the cell one by one.
There are bad connection at the individual connector. Please check the
connector and cables carefully.
The internal temperature of the unit goes too high. Cool down the unit.
The processor can not continue to control the feeding current by any reason.
The unit needs to be repaired.
33