Charging Lithium Battery - Konect PRODUO 80 Manuel D'utilisation

Input power low
Cut-off 10.0V
LITHIUM BATTERY (LIIO/LIHV/LIPO/LIFE) PROGRAM
These programs are only suitable for charging and discharging Lithium batteries with a nominal voltage
of 3.3V, 3.6V and 3.7V per cell. These batteries need to adopt different charge technique is termed a
constant voltage (CV) and constant current (CC) method. The charge current varies according to the
battery capacity and performance. The final voltage of charge process is also very important; it should be
precisely matched with the charade voltage of the battery. They are 4.2V for LiPo, 4.1V for Lilo, and 3.6V
for LiFe. The charge current and nominal voltage as for cell count set on the charge program must always
be correct for the battery to be charged.
When you are willing to alter the parameter value in the program, press Start/Enter key to make it blink
then change the value with INC or DEC key. The value will be stored by pressing Start/Enter key once.
SAFE TIMER CALCULATION
When charging NiCd or NiMH batteries, divide the capacity by current, then divide the result by 11.9, set
this number of minuters as the value for safety timer setting. If the charger stopped at this time thresold,
about 140% of the capacity will have been fed into the battery.
For example :
Capacity Current
2000 mAh 2.0A
3300 mAh 3.0A
1000 mAh 1.2A

CHARGING LITHIUM BATTERY

LiPo Charge
2.0A 11.1V(3S)
After setting the current and voltage press Start/Enter key for more than 3 seconds to start the process.
(Charge current: 0.1 - 5.0A, Voltage: 1 - 6 series)
R:3 SER S:3SER
CONFIRM(ENTER)
to go back to previous screen. Then carefully check the number of cells of the battery pack to charge again.
Li3S 2.0A 12.59V
CHG 022:43 00682
26
This program monitors the voltage of input DC battery. If the voltage drops
below the value you set the operation forcibly terminated to protect the input
battery.
Safety time
(2000/2.0=1000)/11.9=84 minutes
(3300/3.0=1000)/11.9=92 minutes
(1000/1.2=1000)/11.9=70 minutes
The left side of the first line shows the type of battery you select at the users setting.
The value on the left side of second line sets a charge current and the value on the
right side of second line sets the voltage of the battery
This shows the number of cells you set up and the processor detects. "R:"
shows the number of cells found by the charger and "S:" is the number of cells
selected by you at the previous screen. If both numbers are identical you can
start charging by press Start/ Enter button. If not, press Batt type/Stop button
The screen shows the present situation during charge process. To stop
charging press Batt type/Stop key once.