Charging Lithium Battery At Balance Mode; "Storage" Control Lithium Battery - Konect PRODUO 80 Manuel D'utilisation

CHARGING LITHIUM BATTERY AT BALANCE MODE

This is for balancing the voltages of Lithium batteries of the battery pack to be charged. To do this, the
battery pack being charged should have the individual cell connector. And connect it to the individual port
at the right side of charger with a suitable connection cable that fits with your battery pack. And also, you
need to connect the battery output plug to the output of charger.
In this mode, the charging process will be different from ordinary charging mode. The internal processor
of the charger will monitor the voltages of each cell of the battery pack and controls the charging current
that is feeding to each cell to normalize the voltage.
LiPo Balance
2.0A 11.1V(3S)
seconds to start the process.
R:3SER S:3SER
CONFIRM (ENTER)
not, press Batt type/Stop button to go back to previous screen. Then carefully check the number of cells of
the battery pack to charge again.
Li3S 2.0A 12.59V
CHG 022:43 00682
"FAST" CHARGING LITHIUM BATTERY
The charging current is getting smaller as the process goes to the near end term of Lithium battery
charging. To finish charging process earlier, this program eliminate certain term of CV process. Actually,
the charging current will goes to 1/5 from the initial value to end the process while the normal charging
goes to 1/10 during CV term. The charging capacity may be a bit smaller than normal charging but the
process time will be reduced.
LiPo FAST CHG
2.0A 11.1V(3S)
Li3S 2.0A 12.59V
CHG 022:43 00682

"STORAGE" CONTROL LITHIUM BATTERY

This is for charging or discharging Lithium battery not to be used for the time being. The program will
determine to charge or discharge the battery to the certain voltage depending on the voltage of the
battery at its initial stage. They are different from the type of the battery, 3.75V for Lilo, 3.85V for LiPo
and 3.3V for LiFe per cell. If the voltage of battery at its initial stage is over the voltage level to storage,
the program will start to discharge.
The value on the left side of second line sets a charge current and the value on the right
side of second line sets the voltage of the battery pack.
After setting the current and voltage press Start/ Enter key for more than 3
This shows the number of cells you set up and the processor detects. "R:"
shows the number of cells found by the charger and "S:" is the number of
cells "S:" is the number of cells selected by you at the previous screen. If both
numbers are identical you can start charging by press Start/Enter button. If
The screen shows the present situation during charge process. To stop
charging press Batt type/Stop key once.
You can set up the charging current and the voltage of the battery pack being
charged. As you press Start/Enter button the voltage confirmation will be
displayed. And then, if you confirm the voltage and current, press Start/Enter
button again to start charging.
This shows the present state of "FAST" charging. To stop charging arbitrary,
press Batt type/Stop key once.
27