Discharging Lithium Battery - Konect PRODUO 80 Manuel D'utilisation

LiPo STORAGE
2.0A 11.1V(3S)
Li3S 2.0A 12.59V
STO 022:43 00682

DISCHARGING LITHIUM BATTERY

LiPo DISCHARGE
1.0A 11.1V(3S)
Li3S 2.0A 12.59V
DSC 022:43 00682
VOLTAGE BALANCING AND MONITORING DURING THE DISCHARGE
The processor monitors the voltage of individual cells during "storage-mode" and "discharge" of Lithium
battery pack. It tries to normalize the voltages to be equal. For this feature, the individual plug of the
battery pack should be connected to the individual port of the charger.
If the voltage of any one or more cells varies abnormally during the procedure, it terminates the process
forcibly with the error message. If this happens, the battery pack contains the bad cell, or the bad
connection of the cable or plug. You can easily know which one cell is bad by pressing INC button at time
of showing the error message.
BATTERY VOL ERR
CELL LOW VOL
4.14 4.16 4.09
2.18 0.00 0.00
LIHV MODE INSTRUCTIONS
WARNING: LiHV Chg
EndV: 4.35V/Cell
CONFIRM (ENTER)
CANCEL (STOP)
28
You can set up the current and the voltage of the battery pack to be charged.
The current will be used for charge or discharge the battery to reach the
"storage" level of voltage.
The screen shows the present situation during charge process. To stop
charging press Batt type/Stop key once.
The value of discharge current on the left side of screen may not exceed 1C for a
maximum safety and the final voltage on the right should not be under the voltage
level that is recommended by the battery manufacturer to avoid deep discharging.
To start to discharge press Start/Enter key for more than 3 seconds.
This shows the present state of discharge. To stop discharging press Batt
type/Stop key once.
The processor found that the voltage of one of the cell in the Lithium battery
pack is too low.
In this case, the 4th cell is bad. If there happens the connection-break of the
cable or plug, the voltage value may show zero.
Select LiHV battery with standard Voltage 3.8V from setting program, double
confirm the battery type when charging. If it's not LiHV battery, press Stop button
to exit; if it's confirmed LiHV battery, then go to the program.
Warning: The LiHV mode only supports 4.35V LiHV batteries. Do not use any
other battery type in this mode. Never charge a 4.20V LiPo battery under this
mode as it may cause the battery to catch fire or explode.