Konect PRODUO 80 Manuel D'utilisation page 25

LiFe
V.Type 3.3V
is different from correct value the battery can explode during charge process.
LiPo/Lilo/LiFe
CHK Time 10min
you can set the time term to verify the cell count by the processor. Normally, 10 minutes are enough to
perceive the cell count correctly. For the battery of larger capacity, you may extend the time term. But if
you set the time term too long for the battery of smaller capacity, the charge or discharge process can be
finished within the time term with the erroneous cell count. This may cause the fatal result. If the processor
recognizes the cell count incorrectly at the beginning of charge or discharge process, you may extend the
time. Otherwise, you had better use with the default value.
NiCd Sensitivity
D.Peak Default
lower, there is a possibility of premature termination. Please refer the technical specification of the battery.
(NiCd default: 12mV, NiMH default: 7mV)
USB/Temp Select
Temp Cut-off 80C
link the charger to your PC via an optional USB cable. This can utilize the optional software that can show
you the charge process at PC.
USB/Temp Select
Temp Cut-off Enabled
Waste time
CHG/DCHG 5min
time to cool down before being subjected to the next process. The value ranges from 1 to 60 minutes.
Safety timer
ON 120min
Capacity Cut-Off
ON 5000mAh
Key Beep ON
Buzzer ON
The screen displays the nominal voltage of Lithium battery. There are three
kinds of Lithium battery; LiFe(3.3V), Lilo(3.6V) or LiPo(3.7V). This is very
important so you have to check the battery carefully and set it up correctly. If it
It recognise the cell count of Lithium battery automatically at the beginning
of charge or discharge process to avoid from erroneous setting by user. But
deeply discharged battery can be perceived incorrectly. To prevent the error,
This shows the trigger voltage for automatic charge termination of NiMH and
NiCd battery. The effective value ranges from 5 to 20mV per cell. If the trigger
voltage is set higher, there is a danger of overcharging the battery; if it is set
(OPTIONAL) You can select the function of 3-pin port at left side of the unit. It
can be used temperature sensor port or USB port, selected at this screen. If
the port is assigned as a temp. port, an optional temperature probe contacting
the surface of battery can be used. When it is selected as an USB port, you can
(OPTIONAL) You can set the maximum temperature at which the charger should
allow battery to reach during charge. Once a battery reaches this temperature
during charge, the process will be terminated to protect the battery.
The battery is on the cyclic process of charge and discharge can often become
warm after charge or discharge period. The program can insert a time delay to
occur after each charge and discharge process to allow the battery adequate
When you start a charge process, the integral safety timer automatically starts
running at the same time. This is programmed to prevent overcharge the
battery if it proves to be faulty, or if the termination circuit cannot detect the
battery full. Please refer the statement in below to calculate the time setting.
This program sets the maximum charge capacity that will be supplied to the
battery during charge. If the delta-peak voltage is not detected nor the safety
timer expired by any reason, this feature will automatically stop the process at
the selected capacity value.
The beep sounds at every time pressing the buttons to confirm your action.
The beep or melody sounded at various times during operation to alert different
mode changes. These audible sounds can be on or off.
25