Putting Into Use - Simco PINNER 5 Point Notice D'utilisation

War rning:
In order to p prevent da
m ounted las st.
5. Using the spring con
manual D C high vol
First, inse ert part 1 of
the high-v voltage con
5.2 2.3. Pinne er with hea
1. Screw the e pinner he
2. Push the points (4) w
3. Then push h the point
4. Push the Teflon disk
5. Fit the pin nner (see 5
6. Position th he points (
Figure 1.
6. Putting into use
Th he electrod de is put int
ma anual of th he DC high
Pin ner_UM_97520 092710_NL_D_
amage to the high-v
High-voltag
nnector, co onnect the
tage powe er unit).
f the conne ector in the
nnector. Fi nally, lock
ad claw op ption (see
ead (2) into o the body
with the fla at edge thr
ts as far as s possible
k (3) again nst the pinn
5.2.2).
(4) correctl y.
e
to by switc ching on th
voltage po ower unit).
GB_F_V2_1
voltage ca able, part 3
e connection n to the DC h
HV cables s to the DC
e high-volta age conne
the cable by screwin
Figure 1)
(1).
rough the T Teflon disk
into the pin nner head
ner head (2 2).
e DC high voltage po
.
3 of the gl land shou
high voltage power unit
C high volta age power
ctor, and t then twist p
ng part 3 to o part 2.
k (3).
(2).
ower unit ( (please ref
uld be
r unit (see
part 2 into
fer to the
16