Technical Specifications; Installation; Checks - Simco PINNER 5 Point Notice D'utilisation

4. Technical specifications

Operating voltage:
Operating distance:
Short-circuit current:
Operating temperature:

5. Installation

5.1. Checks

- Check that the electrode is undamaged and that you have received the correct version.
- Check that the data on the packing slip corresponds with the data shown on the product
received.
If you have any problems andlor in the case of ambiguity.
please contact Simco-Ion or your regional agent.
5.2. Installation
5.2.1. Summary
The distance from the electrode to the material should be established by experiment. When
adjusted properly, there should be sufficient bonding of the material and no spark-over from the
points must occur.
Metal parts in the immediate vicinity of the electrode cause a shift in the electric field. As a
result, the charging effect is disrupted. The minimum distance between electrode and metal
parts must be 75 mm.
If you have any questions concerning the installation:
please contact Simco-Ion or your regional agent.
5.2.2. Installation
Warning:
- Do not lay high voltage cables along sharp metal parts or in sharp bends and do not
kink them.
- Keep high-voltage cables separated from low-voltage wiring.
- Metal parts near the electrode, including the machine frame, must be earthed.
1. Using the screws supplied, fit the 2 clips to the mounting strip.
Minimum distance between the clips 50 mm.
2. Clamp the electrode in the clips
3. Mount the unit in the place where charging is required (keeping it at a distance of
approx. 12.5 mm from the material to be charged).
4. Using the assembly clamps supplied, fix the HV cable alongside the machine frame to the
DC high voltage power unit.
Pinner_UM_9752092710_NL_D_GB_F_V2_1
30 kV DC max.
12.5 mm minimum at 30 kV.
375 µA at 30 kV (HV resistance 80 MΩ).
200°C max. (at the top of the electrode).
GB
15