Hach 9582sc Manuel D'utilisation Simplifié page 7

3. Connect the sample line to the sample input connector.
4. Connect the sample output to the sample output connector.
Figure 2 Sensor mounting
1 Sensor cable connector
2 Sensor clamping nut
3 Assembled sensor
4 Gasket
4.4 Install the controller
Refer to the controller documentation for mounting and wiring instructions.
4.5 Connect the sensor to the controller
Potential Electrocution Hazard. Always disconnect power to the instrument when making electrical
connections.
5 Flow chamber
6 1/4" NPT sample input connector (not provided)
7 M4 screws (not provided)
8 1/4" NPT sample output connector (not provided)
W A R N I N G
English 7