Bosch TES 501 Série Mode D'emploi page 18

en
4. Clean the individual parts with a deter-
gent solution and a soft brush. If neces-
sary, soak in a warm detergent solution.
Clean the air hole (6e) thoroughly.
5� Rinse all parts with clean water and dry.
6. Fit the steam nozzle (6d) and frothing
tube (6c) back into the metal sleeve.
6c
1
7. Twist the steam nozzle clockwise until
the marks are aligned.
8� Attach the milk frother to the steam
valve. Check that the red mark on the
steam valve is covered.
14
¡
Risk of scalding!
Only use the appliance when the milk
frother (6) is completely assembled and
fitted.
6e
Cleaning the brewing unit
Clean the brewing unit regularly.
To pre-clean the brewing unit automatically:
Press the service button (12) briefly. The
appliance will rinse if coffee was dispensed
previously. It then switches off.
In addition to the automatic cleaning pro-
gramme, the brewing unit (5a) should be
removed regularly for cleaning (Figure E
at the beginning of the instructions).
6d
1� Press the power on/off switch O / I (9) to
switch off the appliance. All lights go off.
2� Open the door (5b) to the brewing unit.
2
3� Slide the red lock (5d) on the brewing
unit (5a) completely to the left.
4. Press the eject lever (5c) down fully. The
brewing unit is released.
5� Grasp the brewing unit (5a) by the
recessed grips and remove carefully.
6. Remove the cover (5e) of the brewing
unit and rinse the brewing unit (5a)
t horoughly under running water.